Since the plosive problem is basically caused by a rush of air from your lips hitting a microphone capsule fast and hard, what you have is a problem of volume. The plosive was too loud compared to everything around it. Not only that, but most of the too-loud bits are in the low end… the bass frequencies. So the fix would be to turn down the volume of your voice when it is hitting the “P.” In an audio editor,
like Audacity (which is open source) you zoom in on the plosive and select everything right up until the voice actually becomes audible. In other words, if the word was “pot,” try not to get any of the -“ah” sound in your selection. You only want the “P” sound. Then you just use a volume reduction tool to turn down JUST the “P.” You may have to experiment (“undo” is the magic-bullet of computer audio editing!) with how much you turn it down, but that may be all you need to do. Watch video in link below
video link : http://wp.me/p8HeNU-1tQ
If adjusting the volume doesn’t get you there, you might just need to reduce the volume of PART of the plosive, the bass part. You do this using equalization (EQ), which is the same thing as volume, only you control what frequencies get turned up or down. Try reducing volume of frequencies below 100 Hz and leave everything else alone. Again, experimentation may be needed.
Article Source: http://EzineArticles.com/4201751